Emulex LP9802DC Uživatelský manuál stáhnout pdf (Strana 32)

Driver for HP-UX - Troubleshooting Section Page 29

lpfcN: 47 : WorldWide PortName doesn't conform to IP Profile

DESCRIPTION: In order to run IP, the WorldWide PortName must be of type IEEE (NAA = 1). This

message is display if the adapter WWPN doesn’t conform to the standard. The NAA is recorded.

LOG: ERROR always lp6000.c

ACTION: Turn off the network-on configuration parameter or have a different WWPN assigned.

lpfcN: 48 : Enable interrupt handler failed

DESCRIPTION: This error occurs if the driver cannot assign an interrupt vector to the host adapter.

LOG: ERROR always lp6000.c

ACTION: Check the configuration of the adapter in the system.

lpfcN: 49 : Adapter Hardware Error

DESCRIPTION: A FireFly error interrupt occured and the status register indicates a non-recoverable

error. The adapter status register is recorded.

LOG: ERROR always lp6000.c

ACTION: This error usually indicates a hardware problem with the adapter, run diagnostics.

lpfcN: 50 : Stray Mailbox Interrupt

DESCRIPTION: Received a mailbox command completion and the mailbox is not owned by the host.

The mailbox command and status are recorded.

LOG: ERROR always lp6000.c

ACTION: This error could indicate a software driver or firmware problem. If the problems persist, report

these errors to Technical Support.

lpfcN: 51 : [29,xx] Check condition received

DESCRIPTION: Could indicate a problem with an FCP target. The check condition response info fields

are recorded. A 29,xx check condition is recorded only in verbose mode.

LOG: ERROR always lp6000.c

ACTION: Check the state of the FCP target

lpfcN: 52 : [Xmit Received] ELS [command response]

DESCRIPTION: Could indicate a problem with an FCP target. The check condition response info fields

are recorded. A 29,xx check condition is only recorded in verbose mode.

LOG: WARNING ELS verbose fcelsb.c

ACTION: No action needed.

1 2 ... 27 28 29 30 31 32 33 34 35

Žádné komentáře

Emulex LP9802DC Uživatelský manuál Strana 32