Emulex LP9802DC Uživatelský manuál stáhnout pdf (Strana 28)

Driver for HP-UX - Troubleshooting Section Page 25

lpfcN: 25 : Mailbox command timeout

DESCRIPTION: A Mailbox command was posted to the adapter and did not complete within 30 seconds.

the Mailbox command and status are recorded.

LOG: ERROR always fcscsib.c

ACTION: This error could indicate a software driver or firmware problem. If no I/O is going through the

adapter, reboot the system. If these problems persist, report the errors to customer service.

lpfcN: 26: FAN timeout

DESCRIPTION: We received a link up event without the login bit set, so the driver waits E_D_TOV for

the Fabric to send a FAN. If no FAN if received, a FLOGI will be sent after the timeout.

LOG: WARNING always fcscsib.c

ACTION: None needed. The driver recovers from this with a FLOGI to the Fabric.

lpfcN: 27: NameServer Registration timeout

DESCRIPTION: Our registration request to the Fabric is not acknowledged within ratov.

LOG: WARNING always fcscsib.c

ACTION: Check Fabric configuration. The driver recovers from this and continues with device discovery.

lpfcN: 28: Nameserver Query timeout

DESCRIPTION: Node Authentication timeout or Node Discovery timeout. A NameServer Query to the

Fabric or discovery of reported remote NPorts is not acknowledged within R_A_TOV.

LOG: WARNING always fcscsib.c

ACTION: Check Fabric configuration. The driver recovers from this and continues with device discovery.

lpfcN: 29: pt2pt timeout

DESCRIPTION: This indicates a PLOGI has not been received, within R_A_TOV, after a successful

FLOGI, which indicates our topology is point to point with another N_Port. Typically this PLOGI is used

to assign a N_Port ID.

LOG: WARNING always fcscsib.c

ACTION: None Needed, driver will recover by configuring N_Port ID as 0.

lpfcN: 30: SCSI timeout

DESCRIPTION: An FCP IOCB command was posted to a ring and did not complete within ULP timeout

seconds. The IOCB command, N_Port ID and SCSI ID are recorded.

LOG: WARNING FCP verbose fcscsib.c

ACTION: If no I/O is going through the adapter, reboot the system; otherwise check the state of the

target in question.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Žádné komentáře

Emulex LP9802DC Uživatelský manuál Strana 28