Emulex LP9802DC Uživatelský manuál stáhnout pdf (Strana 23)

Driver for HP-UX - Troubleshooting Section Page 20

Error Codes Table

Introduction

Error/warning messages are logged only into /var/adm/syslog/syslog.log file. Some messages are

recorded only if the log-verbose configuration parameter is turned on. With the verbose parameter, you

can set a bit mask to record specific types of verbose messages:

Severity Codes

Information and warning messages can be turned ON or OFF by setting/resetting the appropriate mask

bit(s) in the variable 'lpfc_log_verbose' located in the driver configuration module, lpfc.conf.c. By default,

both information and warning messages are disabled. Configuration error (c), error (e), and panic (p)

messages can not be disabled.

Error messages are documented in the following format:

LpfcN: Num : Message

Date: Variables

Where N is the interface number

Num is a unique error code and Message is the error title message

Variables are five possible message-dependent data variables.

• Error description.

• Message status (error, warning or panic), how the error is logged (always or verbose) and the

driver source code location.

• Follow up action required (if any).

Table 3: Severity Code Table

Code Severity

0x1 ELS events

0x2 Device Discovery events

0x4 Mailbox Command events

0x8 Miscellaneous events

0x10 Link Attention events

0x20 IP events

0x40 FCP events

0x80 Node table events

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Žádné komentáře

Emulex LP9802DC Uživatelský manuál Strana 23