Emulex LP9802DC Uživatelský manuál stáhnout pdf (Strana 17)

Driver for HP-UX - Configuration Section Page 14

Load Boot Code

If you are using the HP-UX 11.11 operating system with an Emulex LP9802DC, LP9402DC or

LP8000DC host bus adapter, you must load the boot code before updating the firmware. This procedure

uses the lputil utility, which was installed with the driver.

Prerequisites

• The driver for HP-UX is installed properly.

• You have at least one dual channel adapter.

• The boot code file has been downloaded to a local drive.

Procedure

To load boot code:

1. Start the utility by entering the complete path to lputil. The path in the example reflects the

default installation path. If the installation path was modified, adjust the command appropriately.

/opt/lpfc/bin/lputil

2. From the Main menu, enter 3, Firmware Maintenance.

3. Enter 1, Load Firmware Image.

4. Enter the full path to the boot code file.

The new boot code is transferred to flash ROM.

Caution: Failure to load the boot code will make a dual channel

adapter unavailable after a system reboot.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Žádné komentáře

Emulex LP9802DC Uživatelský manuál Strana 17