Emulex LightPulse LPe1105-M4 HBA Instalační příručka stáhnout pdf (Strana 80)

EMC Host Connectivity with Emulex FC HBAs and FCoE CNAs for the Linux Environment

Installing and Configuring the Linux Host with the Emulex Driver

Removing LPFC Driver source RPM ...

lpfc: Device or resource busy

/usr/src/lpfc/lpfc.conf saved as /usr/src/lpfc/lpfc.conf.backup

The Emulex LPFC Driver has been removed from your system.

Removing Emulex DFC driver startup script ...

Restoring old Emulex drivers...

2. Reboot the host.

Note: When using SLES 8 SP3, the uninstallation procedure does not fully

remove all of the files. Therefore, the lpfc --uninstall command for the tar

archive must be run twice.

Upgrading from the

Emulex v2.x-Series

driver to the

v7.x-Series driver

To upgrade from the v2.x-series Emulex driver to the v7.x-series

driver, the uninstallation procedure discussed above may be used to

remove the previous installation of the v2.x-series driver.

1. Prior to upgrading the driver, all I/O being generated must be

stopped and all applications currently using the Emulex HBAs

and driver must be exited.

2. To remove the existing v2.x-series driver instance, run the

command:

./lpfc-install --uninstall

• This process will create a back up copy of the following files:

– /etc/modules.conf

– /etc/lpfc.conf

– /boot/initrd-

.img

• If RPMs were used to install the v2.x-series driver, the

uninstallation will attempt to remove those RPMs from the

system.

• A new ramdisk will be created with all references to Emulex

drivers removed.

3. Reboot the host.

When the Emulex v2.x-series driver has been removed, refer to the

“Installing the Emulex v7.x-Series driver” on page 68 for instructions

to install the v7.x-series driver.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 181 182

Žádné komentáře

Emulex LightPulse LPe1105-M4 HBA Instalační příručka Strana 80