Emulex LightPulse LPe1105-M4 HBA Instalační příručka stáhnout pdf (Strana 63)

Installation instructions for the Emulex v7.x-Series driver

Installing and Configuring the Linux Host with the Emulex Driver

Installation instructions for the Emulex v7.x-Series driver

Using the Emulex adapter with the Linux operating system requires

HBA driver software. The driver functions at a layer below the Linux

SCSI driver to present fibre Channel devices to the operating system

as if they were standard SCSI devices.

Refer to the latest EMC Support Matrix for specific qualified kernel

versions and distributions.

Please note that the support stated in the EMC Support Matrix

supersedes versions listed in this document.

Enabling the Emulex v7.x-Series driver in RHEL 3.0 U4 and U5

EMC supports the Emulex v7.1.14 driver included in RHEL 3.0 U4

and U5 distributions. In the RHEL 3.0 kernel v2.4.21-27.EL and later,

the Emulex v7.1.14 driver is the default driver integrated into the

kernel.

To enable the

lpfcdfc driver in RHEL 3.0 U4, please refer to

“Installing the IOCTL Application Helper Module on RHEL 3.0 U4”

on page 65. By default, RHEL 3.0 U5 includes the

lpfcdfc IOCTL

Application Helper Module so no steps need to be taken in order to

enable it.

The following procedure provides instructions for enabling the

integrated v7.1.14 driver.

1. Ensure that the

/etc/modules.conf file references an entry for

each installed Emulex HBA.

For each installed Emulex HBA, add an entry:

alias scsi_hostadapter

lpfc

where

is the sequential value of each Emulex HBA installed in

the system, beginning with the number after the last host adapter

number entry in the file. (The first host adapter entry begins with

zero.)

Example:

alias parport_lowlevel partport_pc

alias scsi_hostadapter mptbase

alias scsi_hostadapter1 mptscsi

alias scsi_hostadapter2 lpfc

alias scsi_hostadapter3 lpfc

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 181 182

Žádné komentáře

Emulex LightPulse LPe1105-M4 HBA Instalační příručka Strana 63