Emulex 110 Instalační příručka stáhnout pdf (Strana 80)

EMC Host Connecivity with Emulex Fibre Channel HBAs and CNAs in the Windows Environment

Installation and Configuration

Note: If you are using Emulex STORPort driver 2.01a4 or later on Windows

2003, and are booting externally to an EMC array, you will need to install

using driver version 1.30a9. Driver version 2.10a7 and later require a

minimum of Windows 2003 with Service Pack 2 and STORPort hotfix

Q950903. Since these required patches/QFEs do not come preinstalled on the

Windows 2003 installation CD-ROM, you must install using the older driver

version and then upgrade to 2.01a4 or later after installing the correct service

pack and QFE.

To install Windows:

1. Insert a bootable Windows CD-ROM into the drive and reboot the

system. If your system has a bootable disk already configured

from a previous installation, the software will prompt you to

press any key to boot from CD-ROM.

2. If you are installing Windows to boot from an external array disk,

you will need to supply setup with the adapter driver. To do this,

immediately after the Windows installation begins, press F6

when directed or when the blue screen appears. Otherwise,

proceed to Step 6.

Pressing F6 tells the Windows installer that you want to load a

third-party driver before proceeding with the installation.

If you do not press F6 in time to add the drivers, restart the server

and try again. You will know if you missed the F6 function to

install third-party drivers when the setup returns with a warning

that it cannot find a partition to load the operating system.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 239 240

Žádné komentáře

Emulex 110 Instalační příručka Strana 80